My name is Abigail Smith.  I am a grade 8 student, a 1st degree black belt in Taekwondo and an advent scrap booker.   I have been scrapbooking for about two years and I love designing my own projects.

I hope you enjoy these projects. 

Our Guest Instructor is Abigail Smith

2008 All Rights Reserved

 

"Envelope Invite"

Step 1: Cut a piece of paper, 6" x 6"

Step 2: Line up the top and bottom point at the 6" groove on the Scor-Pal. Score at 4"" and 8, rotate and repeat.

Step 3: Notch out where the lines intersect and fold into envelope shape.

Step 4: Cut two pieces of paper, one 2 " x 2 " (outside of card), the other 3 " x 3 " (for inside of card)

Step 5: Make a mark at 1 1/4" on two opposing sides of the smaller square. Place this 2 " x 2 " piece of paper in the center on the front of the card to cover folds, marks at top and bottom.

Step 6: Make a mark on the envelope, top and bottom to correspond with the marks you made on the

square. Remove piece of paper, make a notch (V shape) starting either side of the mark. The point of the V faces the point of the envelope. Refer to the photo.  (Diana: I used an exacto knife. I did not have a notch tool)

Step 7: Glue the square of paper to the top flap. Glue down the notch you cut.

Step 8: Glue larger square to inside of the envelope. This is the perfect spot for writing your invitation details.

Shaker Box Card

ADDITIONAL SUPPLIES

Micro Beads, Acetate, Halloween Sticker, Foam Tape

Make card from above directions. Do NOT cut notches.

Step 1: Glue 2 " x 2 " piece of cardstock to top flap of envelope.

Step 2: Cut a 3" x3" picture frame out of cardstock, refer to photo. Cut a 2 7/8" x 2 7/8" piece of acetate.

Step 3: Adhere sticker to 2 " x 2 " piece of cardstock on front of card. Outline the piece of cardstock with foam tape.  Add micro beads inside of well formed by foam tape.  Peel off backing from foam tape, lay acetate on top.  Using Scor-Tape, stick cardstock frame over the acetate.